After the cooker is cold to the touch take the jars out and place them on a clean surface, have an alcohol lamp or a lighter and the spore syringe ready. Shake the spore syringe to break up the spore clumps. To be able to shake it it's necessary that there is a small bubble of air in the syringe. If this is not the case, then you can suck approximately 1cc of sterile air into the syringe by placing the tip of the needle into the flame and slowly pulling the plunger back.
Loosen the foil from all of the jars so it can be lifted easily when you inoculate.
Take the cover from the needle and heat it over the flame until glowing red. Let cool for a few seconds
Take the upper foil layer off and put aside upside down.
Pierce the foil at the edge of the jar with the needle app. 1in(2.5cm) deep and inject the spore suspension towards the inner jar surface. You should see a small drop running down the inner surface of the jar towards the bottom. Each jar is inoculated on 4 equally spaced points. You should use 1 - 1.5 ml of the spore suspension per jar so one 10ml syringe is sufficient for 6 -10 jars.
Put the foil on again. Flame sterilize the needle again after inoculating 3 jars to prevent cross contamination just in case a jar wasn't properly sterilized. When all of the jars are inoculated fold the foil edges up and press them firmly together so you get a nice aluminium foil lid. Write the inoculation date and the species/strain information on the foil with an all surface felt tip pen. If you touch something other with the needle during the inoculation procedure except the foil surface of the bottom foil layer immediately flame sterilize the tip again.
Click Here to DOWNLOAD or know more about this ebook
No comments:
Post a Comment